With our starter kit display 4.3 inches you can start programming your application and your graphic design straight away. If necessary, we will be happy to support you with customer-specific hardware adaptation requests and questions about firmware creation.

STM32 Display 4.3 inchSTM32F Display 4.3 Zoll


  • TFT-Display 4,3 inch- 480 x 272 pixel
  • Touch capacitive
  • CPU STM32F429BIT6
  • SDRAM 4Mx32bit
  • NOR Flash 8Mx16bit
  • Ethernet 10/100 - RJ45 via Break Out Board
  • USB Typ-A Host - e.g. for USB memory sticks
  • USB Typ-B - for boot loader and/or gernal communication
  • microSD-Card
  • BLE Module BMD-300
  • BLE- and Wifi-Modul ESP32-WROOM-32
  • Buzzer with sound pressure level min. 90dBA @ 2,73kHz
  • Temperature and humidity sensor BME680
  • 2 x Connector with CAN, I2C, SPI, PWM, ADC, GPIO
  • 3 x LED for general use
  • 1 x Taster for general use
  • 1 x Taster for reset
  • Power supply 12 Volt ± 20%
  • Power supply 12 Volt ± 20% mit UART
  • ST-Link Debug Connector
  • Temperature range -20°C up to +70°C
  • Humidity up to 90% RH bei 60°C


pdficon small Schematic 4.3_inch_Display_Control_Board_V200_Var1.pdf
pdficon small Dimensions 4.3_inch_Display_Assembly_Horizontal.pdf
pdficon small Dimensions 4.3_inch_Display_Assembly_Vertical.pdf
jpgicon small Step File STM32_Display_4.3_Horizontal.zip

We are happy to discuss all your requirements and wishes. You can contact us by phone at 08142/305050 or via email m.bittner@ebs-systart.com.

Our website uses cookies. With regard to data protection, you will receive further information on the collection of data in our privacy policy.

[Hide this note for 30 days]