STM32 Display 3.5 inch - Starterkit
With our starterkit STM32 Display 3.5 inches you can start programming your application and your graphic design straight away. If necessary, we will be happy to support you with customer-specific adaptation requests with regard to hardware development and firmware development.
Features:
- TFT-Display 3,5 inch - 320 x 240 pixel
- Touch capacitive
- CPU STM32F429BIT6
- SDRAM 4Mx32bit
- NOR Flash 8Mx16bit
- Ethernet 10/100 - RJ45 via Break Out Board
- USB Typ-A Host - e.g. for USB memory sticks
- USB Typ-B - for boot loader and/or gernal communication
- microSD-Card
- Buzzer with sound pressure level min. 90dBA @ 2,73kHz
- 2 x Connector and CAN, I2C, SPI, PWM, ADC, GPIO
- 3 x LED for general use
- 1 x Taster for general use
- 1 x Taster for reset
- Power supply 12 Volt ± 20%
- Power supply 12 Volt ± 20% mit UART
- ST-Link Debug Connector
- Temperature range -20°C bis +70°C
- Humidity up to 90% RH bei 60°C
Documents:
Schematic 3.5_inch_Display_Control_Board_V200_Var1.pdf
Dimensions 3.5_inch_Display_Assembly_Horizontal.pdf
Dimensions 3.5_inch_Display_Assembly_Vertical.pdf
Step File 3.5 inch TFT Display with Touch Horizontal.zip
Step File 3.5 inch TFT Display with Touch Vertical.zip
Picture 3.5 inch TFT Display with Touch laterally from above.jpg
Picture 3.5 inch TFT Display with Touch laterally from below.jpg
Picture 3.5 inch TFT Display with Touch frontal from above.jpg
Picture 3.5 inch TFT Display with Touch frontal from below.jpg
Picture 3.5 inch TFT Display with Touch Memory and Connectors.jpg
We are happy to discuss all your requirements and wishes. You can contact us by phone at 08142/305050 or via email m.bittner@ebs-systart.com.