Application and display controller combined in one component - two in one. This enables you to reduce the costs for your overall system to a minimum. Our display boards have the performance to calculate your application and graphics. With inexpensive breakout boards you can place sensors, actuators and necessary interfaces anywhere in your housing and control them directly via the display board. If necessary, we adapt the display, the circuit board, the interfaces, the BOM to your wishes. 

Starter kits are available with the following configurations:

  • Display 3,5 inch withTouch - 320 x 240 pixel - Details
  • Display 4,3 inch with Touch - 480 x 272 pixel - Details
  • Display 5,0 inch with Touch - 800 x 480 pixel - Details

Touch Display 3.5 Zoll  STM32F Display 3.5 Zoll


  • Mechanical Development: adaptation of the display support to your housing requirements
    • Mechanical prototypes can be printed in 3D for evaluation.
  • Hardware Development: Adaptation of the hardware to your individual wishes
  • Firmware Development: Programming of graphics with API for direct use in your application
  • Firmware Development: Programming of new drivers and your application
  • Programming Training: Training for rapid in-house implementation

We are happy to discuss all your requirements and wishes. You can contact us by phone at 08142/305050 or via email



Our website uses cookies. With regard to data protection, you will receive further information on the collection of data in our privacy policy.

[Hide this note for 30 days]