With our starter kit STM32 Display 5.0 inches you can start programming your application and your graphic design straight away. If required, we will be happy to support you with firmware development and customer-specific hardware development.

Display 5.0 inch  Display STM32


  • Display 5,0 Zoll - 800 x 480 pixel
  • Touch capacitive
  • CPU STM32F429BIT6
  • SDRAM 4Mx32bit
  • NOR Flash 8Mx16bit
  • Ethernet 10/100 - RJ45 via Break Out Board
  • USB Typ-A Host - e.g. for USB memory sticks
  • USB Typ-B - for boot loader and/or gernal communication
  • microSD-Card
  • BLE Module BMD-300
  • BLE- and Wifi-Modul ESP32-WROOM-32
  • Buzzer mit Druckpegel min. 90dBA @ 2,73kHz
  • Temperature and humidity sensor BME680
  • 2 x Connector and CAN, I2C, SPI, PWM, ADC, GPIO
  • 3 x LED for general use
  • 1 x Taster for general use
  • 1 x Taster for reset
  • Power supply 12 Volt ± 20%
  • Power supply 12 Volt ± 20% with UART
  • ST-Link Debug Connector
  • Temperature range -20°C up to +70°C
  • Humidity up to 90% RH bei 60°C


pdficon small Schematic STM32_Display_5.0_V100_Var1.pdf
pdficon small Dimensions STM32_Display_5.0_Horizontal.pdf
pdficon small Dimensions STM32_Display_5.0_Vertikal.pdf
jpgicon small Step File STM32_Display_5.0_Horizontal.zip
jpgicon small Step File STM32_Display_5.0_Vertical.zip
jpgicon small Picture Starterkit STM32 Display 5.0 inch - laterally from above
jpgicon small Picture Starterkit STM32 Display 5.0 inch - laterally from below

We are happy to discuss all your requirements and wishes. You can contact us by phone at 08142/305050 or via email m.bittner@ebs-systart.com

Our website uses cookies. With regard to data protection, you will receive further information on the collection of data in our privacy policy.

[Hide this note for 30 days]